樊恒辉-2014-分散性土单轴抗拉强度影响因素试验研究-岩土工程学报-路立娜.pdfVIP

DOI 10.11779/CJGE201406023 2.5 0.8 mm/min pH TU475 A 2014 1987 E-mail: lulina198708@163.com Influencing factors for uniaxial tensile strength of dispersive soils LU Li-na, FAN Heng-hui, CHEN Hua, MA Dong-lin, WANG Zhong-ni, HE Zhi-qiang (College of Water Conservancy and Architectural Engineering, Northwest AF University, Yangling 712100, China) Abstract: In order to measure the tensile strength accurately, by using the self-developed moulds and the electric uniaxial tensile tester and comparing the transitional soils with the non-dispersive ones, the influencing factors for tensile strength and fracture mechanism of dispersive soils are studied. The experimental results show that the tester can effectively avoid the end effect and the influence of weight if the length-diameter aspect ratio is 2.5 and the tensile rate is 0.8 mm/min. The uniaxial tensile strengths of the three kinds of soil samples all decrease with the increase of the moisture content and increase with the increase of compactness and clay content. The uniaxial tensile strength of the dispersive soils is lower than that of the transitional soils and non-dispersive soils. The main reasons are that the dispersive soils have a certain amount of Na+ and alkaline pH. These factors make the diffusion double layers thicker and lead to smaller gravitational and larger repulsion among particles. Thus the tensile strength becomes lower macroscopically. Key words: dispersive soil;