MC6中文说明.docVIP

2.4GHz FHSS USER MANUAL  6 Channel Transmitter（6通发射机） Channel 5（5通道） Throttle Trim（油门微调） Rudder Trim （方向微调） V-tail Elevon Mix On V-tail On（ V尾混控） Elevon Off（三角翼混控） V-tail Elevon Mix Off混控开关  Channel 6（6通道） Elevator Trim（升降微调） Aileron Trim （副翼微调） On/Off switch 电源开关 Switches in upper position Reverses direction（通道反向） of channels1-4 Switches in lower position Normal direction（通道正向） of channels 1-4 2.4GHz FHSS This 2.4GHZ features a unique coding protocol to use this Transmitter with a receiver it must be bound to the receiver. The factory will bind the transmitter to the receiver but should it become unbound or should you purchase a second receiver then please follow the procedure outlined below. （发射机和接收机需绑定。如果工厂没有绑定好发射机和接收机或需买第二个接收机，请按下面的步骤操作） 一、接收机 Connect a bind plug to the receiver. （跟接收机绑定连接） Switch on the power to the receiver, the green receiver LED will now flash. （打开接收机开关，接收机上的绿灯闪） Now pick up the transmitter, before you switch it on please ensure that the throttle is in the lowest position and that all the trims are in the middle position. （拿起发射机，在打开发射机开关前，确保油门微调在最低位置，其他微调在中间位置） Holding the bind switch in the up position now switch on the transmitter. （保持绑定开关在上面的位置，现在打开发射机开关） The transmitter green LED will start flashing and the receiver LED will have gone off. （发射机绿灯开始闪，然后接收机的灯停止闪动） Release the bind switch on the transmitter. （断开发射机上的绑定键） 7.Remove the bind plug on the receiver ,the Green LED will now illuminate on the receiver and will now be bound to the transmitter. （移动接收机上的绑定开关，接收机上的绿灯现在会亮起来，就代表已经绑定好） Finally confirm that you have now have full control over all surfaces and controls. Please note it will depend on your model if you have a 4 or 6 channel radio transmitter.遥控器参数： 1：颜色：银色 2：应用：固定翼、车、船: 3：频段：2.400GHz－2.483GHz: 4：发射功率：≦100mW 5：工作电流：≦120mA: 6：编码方式：PCM1024 7：微调模式：电子微调模式 8：摇杆动态范围80%—120% 9：电源：8.4V－12V 10：混控模式：三角翼混控模式和V型尾翼混控模式 11：反向开关：1通道副翼、2通道升降、3通道油门、4通道方向 12：支持固定翼收放起落架和禁翼 13：低电压提示：电池电压﹤8.4V，电源指示500M