2013广西工程量计算规则(土石方工程)(国外英文资料).docVIP

2013广西工程量计算规则(土石方工程)(国外英文资料) The rules of engineering calculation The following information shall be determined before calculating the amount of soil rock. (1) the determination of soil and rock types: the division of engineering of soil and rock types, on the basis of engineering investigation data and table a. 1-10 of soil classification table and table a. 1-11 after the rock classification comparison. (2) the elevation of ground water level and the reduction of water method. (3) soil, groove, foundation pit excavation (filling) starting level, construction method and operational distance. (4) rock excavation, blasting method, stone slag removal method and operational distance. Other relevant information. General rules. (1) the volume of earth is calculated by the volume of natural compacted before excavating. If you need to convert, you can convert the coefficients in table a. 1-5. Table A. 1-5 soil volume table Natural compact volume Virtual party volume After consolidate volume Loose fill volume 0.77 1.00 1.15 0.92 1.00 1.30 1.50 1.20 0.67 0.87 1.00 0.80 0.83 1.08 1.25 1.00 (2) the volume of the stone is calculated by the volume of natural compacted before excavating. If you need to convert, you can convert the coefficients of the coefficients in table a. 1-6. Table A. 1-6 stone square table Regarding the category Natural compact volume Virtual party volume Loose fill volume Code? party Regarding the stone Sand clip 1.00 1.00 1.00 1.54 1.75 1.07 1.31 1.43 0.94 ? 1.67 ? (3) the average thickness of the excavated soil should be determined according to the average thickness of the above ground level. Basis of earthwork excavation depth, should be used to deliver according to the bottom of the foundation pad surface elevation of construction site, no construction site elevation when consign is used, shall be determined according to the natural ground level. Earthwork. (1) flat ground 1) flat field refers to the construction site within + / - 300 mm thickness of di