AVR芯片的ISP全攻略+熔丝补救方法(国外英文资料).docVIP

AVR芯片的ISP全攻略+熔丝补救方法(国外英文资料) The isps of the AVR chip are all the way up The isps of the AVR chip are complete Parallel programming, the programming method of the earliest, the most powerful, but need to connect more pins, usually need 12 v ~ 24 v high pressure, to show the difference, the following called high voltage parallel programming. The ISP (In System Programmability) is programmed In the System, short for serial download The IAP (In Application Programing) is programming, and BootLoader is similar 1 ISP while using the SPI interface (exception: M64 / M128 UASRT0 interface, such as SPI interface on the Tiny13) pins, but only when the restoration work, and when the download is complete qualified downloader will automatically disconnect the connection port, has no impact on the normal work of (in product application, download must be wont stick in the above). Although the high voltage parallel download can fix any fuse bits, it is impractical for the patch packaging, so the ISP interface is the most commonly used download Although IAP is a new upgrade method, the IAP program itself should be used in a high-voltage parallel download or ISP to burn into a chip The younger AVR chip, such as 4 Tiny13, is too small for the foot, there is an ISP, but there is no [high voltage parallel programming] and special [high voltage serial programming] So, there is an ISP interface, or a more provincial position on the product -- six soldering plates The work premise of ISP The chip has no physical damage 2 chips SPIEN fuse bit = 0 to enable ispsRSTDISBL fuse bit = 1 RESET (if the chip has this fuse bit) Four lines are normal -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- Short circuit? The download is normal - especially considering the connection problem 6 power supply Run the clock ISP clock (which must be less than a quarter of the running clock) 4096Hz 1024Hz / / very abnormal usage, 3768 KHz cryst