学习玉米油加工(国外英文资料).docVIP

学习玉米油加工(国外英文资料) 1 corn tigerming process technology The embryo method and process flow At present, the domestic alcohol industry corn is more dry or half Dry; The wet process was widely adopted in the starch industry. Dry or half The germination rate of the dry method is about 9, and the embryo is oily 21 ~ 25. wet The embryo rate is about 7. The embryo is oily 3O ~ 50 ] The characteristics of various methods and the trial and error of production practices This paper mainly introduces the process of semi-dry process. The process flow is as follows: Corn clears one weishui water one break a sieve to be separated by a suction A force of gravity is graded by a single blast of the embryo 1.2 process specification Clean up: remove impurities by cleaning sieve and use magnetic separator and gravity Remove the metal impurities and stones from the stone machine. Not in the blastocyst There is a large impurity, small impurity content is less than 0.5. Water water: water machine is used to water the cleaned corn. To achieve the best condition of broken corn peeling degerming, namely in ^ hot After the steam, the corn husk and the germ are the first to absorb the swelling and make the skin and the kernel The separation between the skin and the embryo and the endosperm is beneficial. Run water With hot water and direct steam, the amount of water is 3 ~ 6, after water Total stay time 10 min ~ 12 min. Broken: a crusher is used to crush the corn after water Or rolled). After water, the corn is quickly absorbed by the germs The sex is particularly good and not broken, the endosperm absorbs water slowly, its hardness is high and easy Broken. The endosperm was broken into four to six petals. The separation of corn husk, germ, and endosperm: first to be separated by suction The small slag and the corn husk are then separated by the gravity classifier. However, The embryo and the endosperm are then rolled by a mill, and the germ is pressed Flat and endosperm are crushed and then separ