球形顶盖注塑模具设计(国外英文资料).docVIP

球形顶盖注塑模具设计(国外英文资料) Graduation design instructions Graduation design topic: spherical top cover injection mold design Department bar Specialized class The students name School number Instruct teacher hara Top cover plastic design Design topic: top cover product design and mould design Figure 1 spherical top cover parts diagram Chapter one: the formulation of molding process discipline The plastic parts are the top product, and the parts are shown in figure 1. The material of this plastic is made of nylon 1010, the production type is mass production. Process analysis of plastic parts 1.1 raw material analysis of plastic parts The plastic parts are made of nylon 1010, which is thermoplastic. On performance, nylon 1010 It is semi-transparent, small water absorption, good cold tolerance, tough, wear-resisting, oil resistant, water resistant, anti-mold, but water absorption is big. In the form of molding, the wall of plastic is not too thick, and it should be even, and it should not be small, especially for thick wall and deep high plastic. The heating time should not exceed 30min, the temperature of the material temperature is large and shrink, easy to come off the edge, the reduction, the orientation is strong, the injection pressure is low and easy to make the dent, the ripple. Molding cycle according to the plastic parts wall thickness, thick, long, thin, short, in order to reduce shrinkage, dent, shrinkage cavity, the general YiQu forming conditions of high low mold temperature, injection pressure, and the white oil as a release agent; Nylon 1010, the main technical indicators: the density is 1.1 kg/dm, volume is 0.96 dm/kg, bibulous rate is 0.2 ~ 0.4, shrinkage ratio is 1.3 ~ 2.3 s, melting point is 205 t/c, heat distortion temperature is 55 c, tensile yield strength is 62 Mpa, 1.8 x 10 Mpa tensile elastic modulus, bending strength of 88 Mpa, 9.75 hardness HB, breakdown strength 20 kv/mm. Structure and dimension accuracy and surface quality analysis of 1.2 plastic p