第四章课后复习思考题(国外英文资料).docVIP

第四章课后复习思考题(国外英文资料)Chapter 4 the axial force componentA, multiple choiceOne area is A, the area of the net area is the member of the area of the cross section, and the formula for the strength of the force N is the formula.(A) is less than or equal to (B) is less than or equal to(C) is less than or equal to (D)The contents of the unit calculation of the solid abdominal axis are.(A) strength (B) strength and overall stability(C) strength, local stability and overall stability (D) strength, stiffness (length ratio)The parts of the shaft of the shaft are compressed, and the local stability of the flange is less than or equal to (10 + 0.1, which means that).(A) the maximum length of the component is not less than 30, not greater than 100 (B)(C) the maximum length of the maximum length (D) 30 or 100The integral stability formula of the 6 axis pressure bar is less than that.The average stress of section A is no more than the strength of the materialThe maximum stress of the cross section shall not exceed the strength design value of the material(C) the average stress of the cross section is not greater than the critical stress value of eulerThe design value of the axial pressure design of the component is no more than that of the component stability limit7 made of steel Q235 and Q345 steel, respectively, the axial compression column, its cross section and the same slendness ratio, within the scope of the elastic buckling, the critical load of the former, the latters critical force.(A) is greater than (B) less than (C) is equal to or near (D)In the case of the eight axis compressive lattice component, it is used to calculate the total stability of the axis of the imaginary axis, which is because.(A) the overall stability of the lattice component is higher than the actual abdominal component of the same section(B) consider the effect of lower intensity(C) consider the effect of shear deformation(D) considering the effect of single instability on the bearing capacity of the c