粗集料泥块含量及含泥量(国外英文资料).docVIP

粗集料泥块含量及含泥量(国外英文资料) T 0310-2005 coarse aggregate content and mud content test Purpose and scope of application To determine the total mass of dust, silt and clay of the gravel or gravel less than 0.075 mm, the total mass of mud and clay, and the amount of clay particles above 4.75mm. Instrument and material (1) the amount of feeling is not greater than 0.1 percent. (2) oven: can control temperature to 105 + 5 ℃. (3) the standard sieve: 1.18 mm, 0.075 mm square hole screen for the mud content. When measuring the amount of mud, one is sieving at 2.36 mm and 4.75 mm square. (4) containers: barrels or enamel plates with a capacity of about 10L. (5) shallow dish, brush etc. 3 test preparation According to T0301 sampling method, sample in the future by four points method or distributor table T0310 method are classified to the amount stipulated in the (pay attention to avoid the loss of fine powder and prevent contain clay piece of crushed), within the oven at temperature of 105 + 5 ℃ drying to constant weight, divided into two standby after cooling to room temperature. Table t0310-1 and the minimum quality of samples required for mud and mud content Nominal maximum size (mm) 4.75 9.5 16 19 26.5 31.5 37.5 63 75 Minimum mass of specimen (Kg) 1.5 2 2 6 6 10 10 20 20 4 test steps 4.1 the test procedure of mud 4.4.1 said take 1 sample (m0) loaded into the container, add water, soak for 24 h, with his hands in the water elutriation particles (or wash with brush), dust, clay and coarser particles separate, and make it suspended in the water; Slowly pour the turbidity into 1.18 mm and 0.075 mm, filter the particles less than 0.075 mm. The two sides of the pre-test sieve should be moistened with water, and should be careful not to lose more than 0.075 mm in the whole experiment. 4.1.2 adds water to the container, repeat the steps until the water is clear. 4.1.3 flush remaining on the screen of the fine particle, and the 0.075 mm sieve in water (the water slightly higher than the