STM8C语言编程实例.pdfVIP

STM8 的C 语言编程（1）－－基本程序与启动代码分析 现在几乎所有的单片机都能用C 语言编程了，采用C 语言编程确实 能带来很多好处，至少可读性比汇编语言强多了。 在STM8 的开发环境中，可以通过新建一个工程，自动地建立起一 个C 语言的框架，生成后开发环境会自动生成2 个C 语言的程序， 一个是main.c，另一个是stm8_interrupt_vector.c 。main.c 中就是 一个空的main()函数，如下所示： /* MAIN.C file * * Copyright (c) 2002-2005 STMicroelectronics */ main() { while (1); } 而在stm8_interrupt_vector.c 中，就是声明了对应该芯片的中断向 量，如下所示： /* BASIC INTERRUPT VECTOR TABLE FOR STM8 devices * Copyright (c) 2007 STMicroelectronics */ typedef void @far (*interrupt_handler_t)(void); struct interrupt_vector { unsigned char interrupt_instruction; interrupt_handler_t interrupt_handler; }; @far @interrupt void NonHandledInterrupt (void) { /* in order to detect unexpected events during developm ent, it is recommended to set a breakpoint on the following instruction */ return; } extern void _stext(); /* startup routine */ struct interrupt_vector const _vectab[] = { {0x82, (interrupt_handler_t)_stext}, /* reset */ {0x82, NonHandledInterrupt}, /* trap */ {0x82, NonHandledInterrupt}, /* irq0 */ {0x82, NonHandledInterrupt}, /* irq1 */ {0x82, NonHandledInterrupt}, /* irq2 */ {0x82, NonHandledInterrupt}, /* irq3 */ {0x82, NonHandledInterrupt}, /* irq4 */ {0x82, NonHandledInterrupt}, /* irq5 */ {0x82, NonHandledInterrupt}, /* irq6 */ {0x82, NonHandledInterrupt}, /* irq7 */ {0x82, NonHandledInterrupt}, /* irq8 */ {0x82, NonHandledInterrupt}, /* irq9 */ {0x82, NonHandledInterrupt}, /* irq10 *