条码枪设置条码说明书.pdf

METROLOGIC INSTRUMENTS, INC. Area Imaging Bar Code Supplemental Configuration Guide Copyright © 2007 by Metrologic Instruments, Inc. All rights reserved. No part of this work may be reproduced, transmitted, or stored in any form or by any means without prior written consent, except by reviewer, who may quote brief passages in a review, or provided for in the Copyright Act of 1976. Trademarks Metrologic is a registered trademark of Metrologic Instruments, Inc. Products identified in this document are hereby acknowledged as trademarks, registered or otherwise, of Metrologic Instruments, Inc. or their respective companies. TABLE OF CONTENTS SCANNER OPERATION Presentation and Trigger Modes In-Stand 1 Out-of-Stand 2 Out-of-Stand / In-Stand Mode Match 2 Omnidirectional and/or Linear Scanner Modes 3 Aiming and Illumination 5 Data Output 6 Character Suppression 7 Same Symbol Timeouts 9 SCANNER OPERATION – MS1633 SPECIFIC Power Save Modes 10 RangeGate Mode 11 Bluetooth Firmware and Address 12 Inventory Mode 13 CODE TYPES AND DECODE RULES Data Matrix 18 QR Code 21 MaxiCode 21 Aztec 22 Postal 24 Codablock Options 27 PDF Options 27 ii TABLE OF CONTENTS RS232 Software Handshaking 28 Multifunctional USB/IBM Interface 28 INTERFACES Additional Interfaces 29 ENTER/EXIT CONFIGURATION MODE BAR CODE 31 iii SCANNER OPERATION Presentation and Trigger Modes There are four configurable modes for scanning: the presentation mode, the multi-try trigger mode, the continuous trigger mode, and the single-trigger mode. These modes can be configured separately for in-stand and out-of-stand scanner operation. In-Stand * Presentation Mode Multi-Try Trig