1-1-钢板维修方法.pptVIP

* Practical demonstration and practice. * Practical demonstration and practice. * Practical demonstration and practice. * Practical demonstration and practice. * Practical demonstration and practice. * 弹性：稍微弯曲钢板，然后放开钢板，钢板能恢复原来的形状，此种变形称为“弹性变形”，而钢板回弹至原来形状的特性称为”弹性” 塑性：在钢板上施加力量使钢板弯曲，则钢板会稍微回弹至原来的形状，但是受到弯曲的部位，则会出现无法恢复原状的永久变形，此种变形称为‘塑性变形“而钢板不能回弹至原来形状的特性称为”塑性“。 * ON this slide we have the panel repair methods. -first panel repair either by hammmer and dolly or washer welding methods. - and followed by Shringking method. Why do we require shringking? * We have two types of hammer and dolly repair methods These are the ON and Off dolly methods - Push up the lower point / knock down the higher point. - Smooth the low and high points by pressing with a hammer and dolly. -Area accesable from the inside. * When using washer welding, -You have to pull the lower point by welding washers on the lowest point of the damaged area and knock down the higher point of the damage by a hammer. We also use washer welding when we are repairing a panel which is inaccessible from insided. * Shringking. The purpose of this method is to regain the panels rigidity. We have two reasons why the panel becomes streched and lost its rigidity. 1. it was streched by external force. 2. it was streched by over hammering when repairing. * Damage assessment mainly has 4 methods these are: By sight By touch BY straight edge Rigidity check Do you know any other method? If you have a damage like this where do you start checking the damage? Answer: Start with a walk around check and also check the undamaged area. To confirm the extent the damage. * 用四种损伤判断方法作出来的损伤范围 * Practical demonstration and practice. * Removing thepaint film by Single action Sander with 60 to 80 grit san paper. and feather edging with Double action sander with 120 grit sand paper. * Practical demonstration and practice. * Practical demonstration and practice. * 钢板维修的四个标准：原始高度、钢板的强度、柃线、零件的安装位置 * Practical demonstration