JTHC病房呼叫系统.PDF

JTHC 病房呼叫系统 ▲ 概述 病房呼叫系统是供船上病员发送呼叫信号的装置，当病人按动病床旁的呼叫器时，各个呼叫报警器发 出声光报警信号，便于医务人员或值班人员迅速采取措施。 ▲ 组成及功能 该系统由各病房的呼叫器、病房呼叫报警器和病房呼叫控制器组成。 1 船上病员按下病房呼叫器的“呼叫”按钮呼叫医务人员时，装在医生房间和其他有值班人员房间中的病 房呼叫报警器会发出声音报警和闪光报警信号，让医务人员或值班人员迅速采取措施。同时，病房呼叫器 上呼叫指示灯也会闪烁，表示呼叫信号已成功送出。 2 当医务人员或值班人员收到报警信号后，按下冷库呼叫报警器上的“应答”按钮，此时声音报警停止， 指示灯由闪光变为平光。同时，冷库呼叫器上呼叫指示灯也会变成平光，表示相关人员已收到呼叫信号。 3 相关人员赶到病房后将病房呼叫器上“呼叫”按钮复位后，系统复位。 JTHC HOSPITAL CALL SYSTEM ▲GENERAL Hospital call system is applicable for patient in hospital on board to send out calling signal. When the patient could press the button, the call alarm unit will send out audible and visual alarm. So that medical personnel or personnel on duty take the proper measures in time. ▲COMPOSITIONS FUNCTIONS This system is consisted of hospital call unit, hospital call alarm unit and hospital call controller. 1. When patient on board press down CALL button of Refrigerator call unit to call medical personnel, Refrigerator call alarm unit in medical room and other duty personnel will send out audible and flash alarm signal so that medical personnel or personnel on duty take the proper measures in time. At the same time, call indicator light on the call unit will become flash light, which means that call signal has been sent out successfully. 2. When medical personnel or personnel on duty find alarm signal and press down RESPOND button on Refrigerator call alarm unit, audible alarm will stop and flash alarm will become continuous light. At the same time, call indicator light on the call unit will become continuous light, which means that relevant personnel has received call signal. 3. When relevant personnel arrived at hospital and reset CALL button on the call unit, system will be reset.