注塑模CADCAMCAE的系统集成.PDFVIP

28 4 ( ) Vol. 28 No4 2003 8 Journal of Kun ing University of Science and Technology (Science andTechnology) Aug. 2003 CAD/ CAM/ CAE 陈志新, 刘建雄, 迟毅林 ( , 650093) : 描述了以CAD/ CAM 软件Pro/E 及注塑模分析软件为平台, 采用系统集成的方式,并运用 Pro/E 的二次开发工 Pro/TOOLKIT,按并行工程思想, 对注塑模CAD/ CAM/ CAE 系统的设计和 开发进行的分析和研究. : 注塑模;CAD/ CAM/ CAE;Pro/ENGINEER;系统集成 :TG241 :A : 1007- 855X(2003)04- 0053- 04 A System Integrated Approach to Plastic Injection Mould CAD/ CAM/ CAE CHEN Z hixin, LIU Jia nxiong, CHI Yilin (Faculty of Mechanical and Electrical Engineering, Kun ing University of Science and Technology, Kun ing 650093, China) Abstract: With thethought of concurrent engineering and on the basis of CAD/CAM syste Pro/E and injection ould analysis software, an analytical research on the design and exploitation of the plastic injection ould CAD/ CAM/ CAE is ade by adopting syste integrated approach and applying the two- develop ent tool Pro/ TOOLKIT of Pro/E. Key words: injection ould; CAD/ CAM/ CAE; Pro/ENGINEER; Syste integration , ,,, . ,, , , ,, , :., , , , . 20 80 (CAD) , (CAM) , (CAE) , ,. 1 CAD/ CAM/ CAE Moldflow , ,. Moldflow , , . ,, .,, . Moldflow ,, CAD ,,. : 2002- 12- 23; : ( :2001E0016M). : ( 1973.9~ ), ,; : CAD/ CAE/CAM. E- mail:czxchen2002@ yahoo.co .cn 54 ( ) 28 Pro/ENGINEER(Pro/E) PTC , CAD/ CAE/ CAM . , ., , . CAD/ CAE/ CAM , , CAM CAE . , PTC CAD/ CAM Pro/E Moldflow . CAD/CAM/ CAE : , CAM Pro/E CAD CAM ,Pro/E Pro/toolkit .CAD ,, , ;CAM , NC . , Moldflow CAE ., ,: (MF/Flow) (MF/ Cool)(MF/Pack) (MF/Warp)(MF/ SR RESS) (MF/ SHRINK)(MF/ OPTIM) (MF/ GAS)(MF/FIBER), ,. 2