高强大规格等边角钢轴压承载力研究.pdfVIP

Vol. 45 No.l 四川大学学报(工程科学版) 第45 卷第1 期 2013 年 1 月 JOURNAL OF SICHUAN UNIVERSITY (ENGINEERING SCIENCE EDπION) Jan. 2013 文章编号:1仪)9-3087 (2013 )01 ，，(泪74-11 高强大规格等边角钢轴压承载力研究 赵楠，李正良，刘红军 (重庆大学土木工程学院，重庆4αl(45) 摘要:进行了 19 个长细比λ=30 -90 的Q420 口20 mm x20 mm 角钢试件的轴压试验研究。结果表明:此类构件 在长细比λ 45 时，以弯曲失稳破坏为主;长细比λ 三 45 时，以弯扭失稳为主。研究了现行钢结构规范中防止局部 屈曲宽厚比限值公式和计算弯扭失稳的换算长细比取值公式的适用性。采用逆算单元长度法得到了大规格等边角 钢的柱子曲线，研究了此类构件与普通规格等边角钢的差异以及肢厚、肢宽和钢材强度等对柱子曲线的影响。提出 了高强大规格等边角钢轴压构件的承载力计算方法。并且研究了高强大规格等边角钢两端偏心受压的柱子曲线， 给出了长细比修正系数的建议公式。 关键词:高强大规格等边角钢;轴压静力试验;逆算单元长度法;柱子曲线 中图分类号:TM753 ;叹J279.7 文献标志码:A Study on the Bearing Capacity of High Strength Large Size Equal Angl四 Steels Under AxiaUy Loaded Compression ZHAO Nan , U Zheng-liang , UU Hong-jun ( College of Civil Eng. ,Chongqing Univ. ,Chorigqing 4αlO45 ,China) Abstract :The 缸ial compression member test was conducted to investigate the stability performance of these member百， including nineteen Q420 U20 x 20 specimens which slenderness ratio( À) ranged from 30 - 90.ηle test results showed that when slenderness isλ 45 , flexural buckling was observed and when slenderness is λ 三45 ， 1∞al or flexural-torsion or torsion buckling was observed. The applicabili- ty of local buckling wide thickness ratio formula and flexural-torsional buckling conversion slenderness ratio formula w，凶 researched. By means of inverse calculation segment length method , the column c盯ve of the large size equal angle was got.币le compari四n with common size angle and 阳rameter analysis was made. Calculation me由od