高掺量酸浸锰渣烧结试块的制备及其机理的研究.pdfVIP

第35 卷第12 期 酸 硅 通 报 盐 Vol. 35 No. 12 2016 年 12 月 BULLETIN OF THE CHINESE CERAMIC SOCIETY December ,2016 高掺量酸浸锚渣烧结试块的制备及其机理的研究 曾思成，邱树恒，王鹏，钱国权 (广西大学材料科学与工程学院，南宁 53仪刷) 摘要:本文以酸浸锺渣为主要原料制备烧结试块，研究了烧成温度、成型压力、粘土掺入量和电石渣掺入量等因素 对试块抗压强度和相组成结构的影响。结果表明:当烧成温度II∞C，成型压力 15 MPa，酸浸锺渣81% ，粘土掺量 9% ，电石渣掺量 103串时，烧结试块的抗压强度达到最大，可达到63.52 MPa;该条件下的XRD 分析表明，鳞石英、钙 硅石等新晶相生成，硬石膏含量增大，以赤铁矿、石英和硬石膏为骨架，赋予试样强度，硬石膏含量的增大说明起到 了固硫的作用，环保效益明显。 关键词:酸浸锺渣;烧结;抗压强度 中固分类号:V254.2 文献标tR码:A 文章编号:1 ∞1-1625 (2016) 124227-05 Preparation and Mechanism of Sintered Briquettes with High Content of Acid Leaching Manganese Slag ZENG Si-cheng ,QIU Shu-heng , WANG Peng ,QIAN Gω-qωn ( College of Materials Science and Engineering ,Guan事i University ,Nanning 53α沁4 ， China ) Abstract: Sintered briquettes were prepared by acid leaching manganese slag ,which had been compared at di证erent factors ,such as sintering temperature ,molding press田e and content of clay and carbide slag ,to access the effect of factors on compressive strength and ph困e structure to the blocks.ηle results show 出at the compressive strength of the sintered brick can reach to the maximum 63. 52 MPa ,when the sample under the 11∞吧 ,molding pressure 15 MPa and the content of acid leaching manganese slag ,clay and carbide slag is 81 q毛， 9% and 10% respectively. 币le X-ray di曲action reveals that tridymite and wollastonite 缸e grew and the content of anhydrite is increased. The framework of the block is made by Hematite ,quar