连退炉内炉辊热变形对带钢瓢曲变形的影响.pdfVIP

第43 卷第2 期 中南大学学报(自然科学版) Vo1.43 No.S 2012 年5 月 Journal of Central South University (Science and TechnoJogy) May 2012 连退炉内炉银热变形对带钢瓢曲变形的影晌 唐夜，杨静，苏岚，江海涛，杨茎 (北京科技大学高效轧制国家工程研究中心，北京， 100083) 摘要g 利用有限元法，采用单锥度辍作为炉银初始辍形，分别通过热应力计算和屈曲分析，连续退火炉加热段和 快冷段内炉辑热变形及其对带制瓢曲变形的影响。研究结果表明z 在加热段，炉较热变形后，随着炉辄温差的增 太，炉辍形状分别为双锥度棍、单锥度棍和 UM 型棍，且妒辘总、锥度随温差增大而减小:当炉较温差在一定范 围之内时，炉银热变形对防止带钢瓢曲变形有利;在快冷段，炉辍热变形后，炉辑变为双锥度辘，随炉辑温差的 增大，炉辍总锥度变大，且带钢更容易发生瓢曲变形.基于计算分析，从炉辍热变形角度考虑，对加热段和快冷 段的炉辑的温差控制及炉辍选择给出了合理的建议。 关键词z 连续退火炉g 炉辍g 热变形z 温差z 带钢g 瓢曲 中图分类号， TG156.2 文献标志码， A 文章编号， 1672-7207(2012)05-1724-08 Influence of roller thermal deformation on strip buckling in continuous annealing furnace TANG Di , YANG Jing , SU Lan, J lANG Hai-tao, YANG Quan (National Engineering Research Center ofAdvanced Rolling, University of Science and TechnoJogy BeijiI毡， Beijing 100083, China) Abstract: FEM wωused to investigate 世le influence of roller thermal deforrnation on the strip buckling in the heating and rapid cooling sections of the continuous 阻R国ling fumace by tbennal stress calcuJation and buckling analysis, and the single taper roller was chosen as 出e original roller type. In the heating section, the roller type was changed to be tbe double tap町 roller， the single taper roller and M sbape roller witb the increase of the 忧mperature difference , accompanied by the decrease of tbe ta时 roller taper. Within ce阳n temperature difference, the thennal defonnation of roller is helpfulωprevent 也.e s时P buckling. In the rapid cooling section, the single taper roller is changed to be t