无头轧制模拟实验台组态技术的研究与开发.pdfVIP

第 卷 第 期 河 北 工 业 大 学 学 报 年 月 37 1 2008 2 Vol.37 No.1 JOURNAL OF HEBEI UNIVERSITY OF TECHNOLOGY February 2008 文章编号：1008-2373 (2008) 01-0063-05 无头轧制模拟实验台组态技术的研究与开发 王宏文，刘 丽，黄伟杰，刘通学 （河北工业大学 电气与自动化学院，天津 300130 ） 摘要 简要介绍了自主研发的无头轧制模拟实验台的硬件构成及控制系统，重点介绍了采用西门子的 WINCC V6.0 组态软件设计的该实验平台的监控系统．研发的监控系统通过MPI 与PLC 进行通讯，能够迅速、准确、有 效的反映实验情况，使用方便，并能对电机、变频器、位置编码器等关键设备的运行进行实时故障检测，为开发 无头轧制系统专用组态软件打下了良好的基础． 关 键 词 无头轧制；监控系统；组态软件； WINCC 中图分类号 TP2 文献标识码 A The Research and Development of Configuration Technology of Endless Rolling Simulation Experiment Platform WANG Hong-wen, LIU Li, HUANG Wei-j ie, LIU Tong-xue ( School of Electrical Engineering and Automation, Hebei University of Technology, Tianj in 300130, China ) This paper describes the hardware structure and control system of the endless rolling simulation experiment platform, and especially introduces the monitor system of the endless rolling simulation experiment platform, which are developed with configuration software of SIMATIC WINCC V6.0. The monitor system communicates with PLC by MPI, ’ reflects experiment platform s work situation flexibly, rapidly, accurately and effectively. The monitor system has real- time fault-diagnosis function to those key equipments such as motors, inverters and position encoders, making good foundation for develop special configuration software for endless rolling system. ； ； ； endless rolling supervise control system configuration software WINCC 0 引