PKPM说明（国外英文资料）.doc

PKPM说明（国外英文资料） PKPM08 seminar notes Five more The 2008-5-19 New changes in version 08: Extended floors (broad floors) The flat modeling space is complementary to the SATWE interface New interface, automatic selection, automatic node Structural parts of steel: 3d modeling, two-dimensional computation Masonry recombination 08 new features: Four modes of modeling PM modeling Direct reading building (APM) modeling Read the CAD in CFG transshipment Complex space modeling (originally only in PMSAP, STS) Merge the modeling operation to achieve the three-in-one It turns out that PMCAD1, 2, 3 merges into one Integrate the original PM2 floor operation, move to PM1 Automatically generate floor board This layer is automatically generated by this layer Panel translucent display (optional) Transparent display of plate holes Still can make the wrong layer board Can make any shape of floor hole The suspension panel can choose the width and shape of any section Load concentration uniform input All load is uniform input Added to the load (the previous three times), all the computing software can be read in together The load of the crane is added Modified strength Break layer model limit, flexible arrangement component The unified shaft network of the whole building is changed to the independent axis network of each standard layer, cancel the alignment of the nodes in the floor, and merge the operation One axis can only be set up with a beam limitation, one axis can be bribed, and the bridge between the two floors is cancelled Break the height limit of the floor and adjust the height of the column Increase the jump bar, the higher column, the easy to make the column Any column can be connected to the other layers Various inclined beam arrangement Wrong layer inclined beam, The beam goes down, and what can be connected to what can be connected (to have a node) and the force can be passed without the false column (solving the problem of sloping roofing) Increase the cross section of th