冲压填空（国外英文资料）.doc

冲压填空（国外英文资料） It is the highest level of murder, and even the forensics cant identify the cause of death... A, fills up the topic The working parts of the cutting die are mainly convex, concave and concave mold. According to the stamping process content of the die, the stamping die can be divided into single process die, compound die and stage die. The mold base parts of the stamping die include the upper and lower module, guide and guide. The basic process of stamping processing can be divided into two kinds. The guide and guide should be used in the assembly of the module. 6. Cold stamping process at room temperature, the pressure machine, using the mould to pressure on the material, make its produce a separation or plastic deformation to obtain the required parts of a pressure processing method. In order to make the die-hard molds work smoothly and smoothly, the shaft line of the die pressure center and the mold handle must be required to overlap (or not). The closing degree of a common crank press is the distance between the bottom and the surface of the work table when the bottom is fast. The closing height of the die is the distance between the top of the die and the lower plane of the die. When selecting the pressure machine, the closing height of the die must be between the maximum closing height of the press and the minimum closing height. The pressure machine with overload protection is the friction press. The adjustable punching machine is eccentric press. The cutting process consists of two processes, which are the blanking and the punch. The deformation of the shock wave consists of three stages of deformation, such as the stage of elastic deformation, the plastic deformation stage and the shear separation phase. The section of the common blanking section has four distinct areas of the Angle belt, the light belt, the fracture belt and the burr. The total impact pressure of the blanking dies includes cutting force, unloading force, pushing force and top