加热督工艺（国外英文资料）.doc

加热管工艺（国外英文资料） Electrothermal tube process: Bottom material: stainless steel cutting of open material machine; Winding: the automatic motor winding the wire; Adding powder: the filling machine puts the heater and the powder into the pipe. Shrinkable tube: tube shrink tube; Mowing: a small lathe to remove the process plug. Annealing: heat treatment of electric annealing furnace; Gouge: diggings. Cut a bar: a small punching machine makes the two leads the same length. 1: high voltage, resistance and size of a high pressure instrument, resistance watch, tape measuring tube. Oven or electric oven high heat discharge, small lathe for the head of the car. The polished machine grinds the two ends; Check the quality of the polishing. Welding: argon welder welded pipe and casing (fastener); Bend: pipe bending tube forming; The drying of the oven and the insulation of the insulation watch. Polish the polishing machine; Electric welding plug for welding machine; The seal and moisture-proof; Final inspection: high pressure instrument, insulation watch, resistance watch, tape measure and caliper for all electric, exterior and dimension inspection. 20. The finished product packaging One, cut pipe (down) To measure the specification of the metal pipe of the electric heating tube, the main test of each batch of electric heating tube shall be less than or equal to 0.2mm. The thickness of the tube is less than or equal to 0.2mm. The incision of the electric heating tube shall not be caused by the friction between the cutter and the cut surface; The width of an electric heating tube should not be greater than 2.5 mm. The length of the electric heating tube is plus or minus 0.5 mm. Self-examination, the first inspection by the inspector, and the inspection; Work clamps and equipment: white steel knife, steel plate, tape, caliper, meter lathe. Two, chamfering. 1, the electric heating tube on both ends of the inner hole chamfer 0.3 x 45 °, can not have burr; The electric heating tube is