用点规范（国外英文资料）.docVIP

用点规范（国外英文资料）1 summary of electricity this temporary electricity engineering construction layout when considering the scene lay lines and the length of the line loss and voltage drop, and according to the actual field power supply, transformer room, in the south set up the built-in 1-1 and 1-2 two total distribution box, from the total distribution box 1-1 for 4 #, 5 # tower, tower steel processing workshops and office area utilization, from the 1-2 total distribution box for 6 # tower and steel workshop processing power, and the scene with ac arc welder, woodworking machinery, plug-in concrete vibrator, plate vibrator, electric cutting machine, of commonly used electric shocks and drilling tools. The rest of the line shall be set up and laid out except for the power supply to the main distribution cable. Cable of the buried depth of not less than 0.7 m, and the cable is close to the top, bottom, left and right side of the installation is not less than 50 mm thickness of fine sand, then cover the hard protective layer, such as brick and along the path direction signs, buried cable passing place in steel casing protection, to ensure that the cable is not subject to mechanical damage. The whole system, distribution system adopts TN - S outdoor section with a total score distribution box and switch box, switch box connected to the electricity equipment, power and lighting shunt Settings, cranes and construction lifts etc. Large power equipment grounding. During the peak construction period, the construction site is used as follows: 1-1 general distribution box construction machinery listTower crane QTZ100 49.2 98.4 2 ssangyong elevator SC200/200 2 66 132 3 welder 2 40 80 4 bar cutting machine GQ - 40 f 5 steel bar bending machine 2, 5.5, 11 GW - 40 j 2, 3, 6 6 reinforced straightening machine GJ - a set of silk machine 1 11 November 7 steel 40 KE x 3 ~ 4 2, 3, 6, 8 concrete vibrator Ф 6 1.1 6.6 9 woodworking circular saw 50 G - 10 2, 3, 6, 10 other small construction si