试验十、8路8位A_D转换器接口设计试验（国外英文资料）.docVIP

实验十、8路8位A_D转换器接口设计实验（国外英文资料） Experiment on the design of an A/D converter interface for ten and eight roads One, the purpose of the experiment Understand how ADC0809 converters work Master the design and programming of interface circuit of 51 single chip and ADC0809 converter Second, experimental equipment A/D conversion module (ADC0809) Microcomputer minimum system Static digital tube display module Third, experimental requirement A simple digital voltmeter consists of A single chip microcomputer, A/D conversion module, and A digital tube display module. The first and third legs of the potentiometer that can be adjusted by hand on the experimental box are connected to + 5V and the ground, and the 0 ~ 5V (0 ~ 5V) of the output of the feet is the input of the digital voltmeter. The current voltage value measured by the digital tube is accurate to 0.1 V. 20 values were measured from 0 to 5V, and compared with the calibrated multimeter measurements. The principle of experiment Computer processing of information into digital quantity, and to control the field control, the controlled object is usually continuous variation of analog and analog must be transformed, into digital quantity into computer to process, the process of converting analog to digital quantity known as the A/D conversion. ADC0809 works in principle and structure ADC0809 single-chip CMOS data acquisition devices, 8-bit 8-channel multiplexing, control logic microprocessors compatible. The conversion technique of 8 A/D converters is the successive approximation method. A comparator with high input impedance. A 256R has an array of partial voltages that simulate switch trees to approximate the input voltage. The device does not require an external zero or full range adjustment. By locking, reusing address decoding, TTL 3-state output, it is convenient to interface with microprocessors. The logic is shown in figure 10-1. EMBED Visio. Drawing. 6 Figure 10-1 internal logic diagram 10-2 ADC0809 pins A single