超微远程操纵器仿单（国外英文资料）.docVIP

超微远程控制器说明书（国外英文资料） Note: you must wait for the relay to ring twice and the system will search for the signal (green for 3 seconds) before sending a message. After setting the master number, redraw the power of the controller to get the system into the normal working state, and notice that this time it is not necessary to set the key. Wait for about 5 minutes (controller search signal and initialization time). When the signal is not found, the green light on the controller flashes, about a second; After the signal was found, the lights on the controller were flashing, about a third of a second. If the signal is not searched for a long time, you can reactivate the power supply and restart the system and search for the signal. Control methods: (1) if the system to search the signal after, can use the phone of the host controller texting control appliances 1 open, controller after received text messages, will open the electrical appliances 1 and reply control appliances 1 open, said the operation was successful. The host can query the status of the appliance at any time, can send the text query work state to carry out the query. (2) the message control The control command has the following: Control appliances 1 open, control appliances 1 off, control appliances 2 open, control of electrical 2 off, control appliances fully open, control electric barrier, to track the status of electric equipment Call control Can make a phone call to control the switch of relay, each call controller can change the original working condition, the relay action will automatically hang up the phone, after only set to owners phone number of the dial is useful. Text Settings and return instructions Control messages Return messages Complete the function Control electrical 1 open Control electrical 1 open The common end of the appliance 1 is short to the usual start Control electrical 1 pass Control electrical 1 pass The common end of the appliance 1 is short with the usual closed end Control el