CAD 试题(国外英文资料).docVIP

CAD 试题 So a local view must be part of a basic view. (to) The view that is obtained from the plane projection, which is not parallel to any basic projection, is called an oblique view. The oblique view is part of the basic view. (wrong) In the partial view and italics, the identity of the fault location, the identity of the view direction and the identity of the view location (wrong) in any case Because cutting is imaginary, it doesnt really cut the machine and take it away. Therefore, when a view takes a section, the rest of the view should be drawn by the complete machine (right) 28 when the main contour line and horizontal line in the graph into a 45 degree Angle, the graphic section line shall be painted with the parallel to the horizontal line into 30 or 60 degrees, the tilt direction and other graphic profile line is consistent, because the cutting is imaginary, so on the sections of the cutting plane turning point should draw lines (wrong) The profile is often used to express the shape of the section of the machine, such as ribs, spokes, keyways, etc., and the profile is also called a section. (wrong) The structure of the part of the machine, which is more than the proportion drawn by the original figure, is called a partial magnification. The proportion of the drawing of a local enlargement is possible by 1:1. Long pieces of machine (shaft, shape, connecting rod, etc.) when the shape of the length direction is consistent or changed by a certain rule, the drawing is shortened and shortened. (to) Our national standards stipulate that when using the third Angle of view, we must draw a third Angle in the drawing (right). An upright right-handed spring, if placed upside down, will turn into a left-handed spring (wrong). All threads of thread are the same inside and outside threads. Two cogs with each other, they must keep the same shape, the same number of modules, and keep the circle at the time of assembly. The top 2 2010-06-13 13:59 boomcow 748 fans Core memb