Protel使用中遇到的问题说明(国外英文资料).docVIP

Protel使用中遇到的问题说明 The problem that is encountered in the use of Protel Q: why not display the symbols in the PROTEL Complex: whether you are in the SCH environment, or in the PCB environment, there are some special characters in the PCB environment that cannot be displayed because the word is reserved. Question: the net name is the same name as the port of the same name Answer: yes, PROTEL network can be generated in a variety of ways, when you are in the hierarchy chart to a port - the port, each route map can use the same NET name, they will not connected by network name is the same. But please do not use the power port, because it is global. Q: please import the PADS file in PROTEL99SE. Why did the soldering disk property change Complex: this is because of the difference between the two software and each version, and it is usually possible to make a single move. Q: can you tell me the Yang big shrimp: why the power by the software logic diagram into protel, unable to attribute changes in protel, as long as a change, otherwise not reality, or the whole display attributes? Thank you very much! Complex: if fully displayed, you can make a general editing, showing only the desired parts. Q: what about the principle of copper? Complex: copper should be more than twice as long as your safe distance. This is the general knowledge of LAYOUT. Q: is there any improvement in the automatic layout of Potel DXP? Can the import package be automatically arranged according to the layout of the principle diagram? Complex: the PCB layout does not have a certain intrinsic connection to the layout of the schematic diagram, so the Potel DXP does not automatically exclude the layout of the schematic diagram in the automatic layout. (according to the component classes created by the subgraph, the PCB layout is supported by the connection of the schematic diagram). Q: where is the information about signal integrity analysis purchased Complex: Protel software is equipped with a detailed ana