route敕令应用说明(国外英文资料).docVIP

route命令使用说明 The Windows route command USES detailed instructions 1. The specific function This command is used to display and modify entries in the local IP routing table. Using a no-take ROUTE can show help. 2. Grammar, The route [-p] [[[]] [[[]] [] [[[] [] [] [] [] [[[]] [] [[[]] [] [[[] [] [] [[[]] [] [] Metric] [if interface] 3. The parameters that The -f Clear all is not the main road by (subnet mask 255.255.255.255 routing), loopback network routing (target for 127.0.0.0, subnet mask 255.255.255.0 routing) or multicast routing (target as , subnet mask for 240.0.0.0 routing) in the routing table entry. If it is combined with one of the commands (such as Add, Change, or Delete), the table will be cleared prior to running the command. -p When used with the Add command, the specified route is added to the registry and initializes the IP routing table when the TCP/IP protocol is started. By default, the added route is not saved when the TCP/IP protocol is started, and when used with the Print command, the list of permanent routes is displayed. All other commands ignore this parameter. The location of the permanent route in the registry is HKEY_LOCAL_MACHSYSTEMCurrentControlSetServicesTcpipParametersPersistentRoutes. Command specifies the command to run. The following table lists valid commands. destination Specify the network target address of the route. Target address can be an IP network address (including the network address of the host address is set to 0), for host routing is the IP address, for the default route is 0.0.0.0. mask subnetmask Specifies the netmask that is associated with the network target address (also called the subnet mask). The subnet mask can be an appropriate subnet mask for the IP network address, and the host route is 255.255.255.255 The default route is 0.0.0.0. If ignored, use the subnet mask 255.255.255.255. The target address cannot be more detailed than its corresponding subnet mask because of the relationship between the target ad