神木煤制中低温热解用型煤工艺参数优化研究_杨芊.pdfVIP

  • 7
  • 0
  • 约1.84万字
  • 约 5页
  • 2017-06-06 发布于河南
  • 举报

神木煤制中低温热解用型煤工艺参数优化研究_杨芊.pdf

神木煤制中低温热解用型煤工艺参数优化研究_杨芊

网络出版时间:2015-06-01 14:19 网络出版地址:/kcms/detail/11.3676.TD1419.017.html Vol.21  No.3    第21卷第3期 洁净 煤 技 术   2015年 5月 Clean Coal Technology May  2015  神木煤制中低温热解用型煤工艺参数优化研究 杨  芊,刘德钱,梁世航,康  旋,周  杨,党钾涛,解  强 (中国矿业大学(北京) 化学与环境工程学院,北京  100083) 摘  要:为制备中低温热解用型煤,以我国典型低阶烟煤神木煤为原煤,以煤焦油重质组分及沥青为 黏结剂,研究成型压力、水分、黏结剂种类及添加量对型煤冷热强度的影响,考察复合黏结剂配比对型 煤冷热强度的影响规律。 结果表明:型煤的强度随着压力和水分的增加呈先增大后减小的趋势;黏结 剂种类对型煤强度的影响作用不同,煤焦油和煤沥青添加量的增加分别增强了冷强度和热强度;在成 型水分13%、成型压力141MPa、煤焦油重质组分质量分数9%和煤沥青质量分数为16%的优化工艺 条件下,型煤的冷、热强度均较优,可以满足中低温热解直立炭化炉对原料的要求。 关键词:神木煤;冷热强度;型煤;黏结剂;中低温热解 - - - 中图分类号:TQ536;TD849      文献标志码:A      文章编号:1006 6772(2015)03 0060 05 Process parameters optimization of briquette preparation from - Shenmu coal for mid low temperature pyrolysis YANG Qian,LIU Deqian,LIANG Shihang,KANG Xuan,ZHOU Yang,DANGJiatao,XIE Qiang (School of Chemical and Environmental Engineering,China University of Mining and Technology(Beijing),Beijing  100083,China) - Abstract:In order to preparebriquettefor pyrolysisat mid low temperature,Shenmu coalwhichwastypical low rank coalwasadopted as the sample,theheavy componentof coaltarandasphaltwereusedasbinder.Theeffectsof briquettingpressure,moisture,bindertypesand additive amount on cold strength and thermal strength of briquette were studied.The influence rule of binders ratio on the cold and hot strength of briquettewas investigated.The results showed that,with the increase of pressure and moisture,the briquette strength increased first,then decreased. Different binders had diff

文档评论(0)

1亿VIP精品文档

相关文档