手机结构件工艺简介（国外英文资料）.docVIP

手机结构件工艺简介（国外英文资料）Part 1: shell: plastic casing, plastic decoration, plastic battery coverA, material:Common GE PC + ABS - 1200HF and electroplated ABS plastic. PC + ABS material is characterized by toughness, good sealing, high mechanical strength, chemical resistance, texture, high liquidity and easy injection molding. The electroplated grade ABS is lower than PC + ABS, which is mainly used for plating decoration. There is already a type of GE PC + ABS (type 1300HF) that can be sprayed and plated.Other available materials: PC, fiberglass reinforced PC + ABS, LG and samsung PC + ABS.Surface treatment technology: spray + UV, electroplating, silk printing, etch, and leatherSpray painting:(1) materials including paint, UV (protective effect), thinner. The factory (or the paint factory) will adjust the paint according to the customers demand, and form a variety of color scheme. Spraying way hand spray and spray machine (automatic spraying line), hand spray is mainly used to give customers proofing, to confirm the color scheme, note that the hand spray color effect will be with jet machine existence chromatism. Machine spray is used during mass production. The automatic spray line is usually between 80 and 400 meters long (two spraying, three spraying), and the capacity is 5000 to 200,000 parts per ring.(2) color control:A, the ratio of paint dilution, the thickness of the spray paint, the light of UV, the effect on color effect is greater.B, the effect of material -- in principle light paint USES light color material, dark paint USES dark material;C, certain special color must first spray two different primers, before the UV, can show the good color effect, if red, the general first spray silver lacquer, then spray red paint.D, light color paint spraying problem - light color paint shading rate is very low, directly spray on the chassis, the color will come out the material color effect (especially black material), at the same time easy to motherboard lights reflecting