空予器（国外英文资料）.docVIP

空予器（国外英文资料） An air feeder is a heat exchanger that USES the exhaust heat of the boilers tail to heat up the burning air. The air feeder is divided into thermal and regenerative (regenerative or rotary) by the heat transfer formula. Heat-conducting tube preheater; The rotary air preheater belongs to the regenerative type, and the rotary air preheater is divided into two kinds: the heated surface of the heating surface and the hot surface of the smoke wind shield. The 1.2 configuration boiler is equipped with two three-point, three-point, three-point, three-point type air preheater. The model is 2-32.5 VI (T) -2185 SMRC, produced by ABB of America, which is set at 13.8 M operating layer. The three-point warehouse is characterized by a high pressure of hot air, dried coal powder and the coal dust to the furnace. The second wind goes directly through the air and enters the boiler bellows to burn. The 1.3 action air preheater is a heat exchanger that USES the exhaust heat to heat the air. The air presser can further reduce the smoke Temperature, reduce the heat loss of exhaust smoke; At the same time, we will raise the air temperature required for combustion, improve fuel ignition and combustion conditions, reduce the total combustion loss, and improve the heating efficiency of boiler units. 1.4 structure of the air preheater is mainly composed of upper and lower connecting plate, rigid and ring rotor, heat storage element, three to seal, shell, main bearing, bearing, gear, fluctuation of bearings and accessories. The lower end of the cold end of the connecting panel, the main support and the sub-pedestal, are the main components supporting the overall weight of the preheater. Especially in the middle beam of the cold end, about 90% of the weight of the entire preheater. The rotor is made up of multiple fan-shaped modules, which are important components for carrying heat transfer elements. The heat transfer element is the thousands of highly efficient, high-efficient, he