网络技术模拟试题及答案(一)（国外英文资料）.docVIP

网络技术模拟试题及答案(一)（国外英文资料） Network technology simulation questions and answers (a) [source: this site | author: guangzhou domain tech center | date: on October 12, 2009 | browse 476] font: [little] in the big one, the single item choice (20 item in this topic, each item 1 minute, a total of 20 points) in the four choices of each item listed is only one option is to meet the requirements of the title, please fill out the letter of the correct options before in parentheses after the question. Using full-duplex communication, the directional structure of data transmission is () A. you can transmit simultaneously in both directions B. It can only be transferred in one direction C. it can be transmitted in two directions, but not at the same time D. None of the above Using asynchronous transmission, the data bits are 7 bits, 1 bit checkbit, 1 stop bit, and the communication efficiency is (). A. 30% b. 70% C. 80% d. 20% The data transfer rate for a T1 carrier is () A. 1Mbps b. 10Mbps 2.048 Mbps 4. By adopting the technology of phase amplitude modulation PAM, can improve the data transfer rate, with eight kinds of phase, for example, each phase 2 kind of amplitude values, can make a yards yuan said the number of binary digits for () A. two b. eight 16 bit d. 4 If the network shape is a closed loop consisting of the site and links to the site, the topology is called (). A. star topology b. bus topology C. loop topology d. tree topology To correct a mistake by using the sea code, if the information level is 4, the redundant bits should be at least (). A. two b. three D. four In the rs-232c interface signal, the connection direction of the data terminal ready (DTR) signal is (). A.dce - DCE - DCE - DCE C. DCE. DCE The type of connector used by the rs-232c mechanism is () A. DB - 15 connector B.D b-25 C. DB - 20 connector d. rj-45 9. Using the AT command set for MODEM programming setting, now let the MODEM to complete with audio dial perimeter (0), and pause for 2 seconds and then