化工泵各零部件考验请求与改良方法(国外英文资料).docVIP

化工泵各零部件检修要求与改进方法(国外英文资料) 1 coupling inspection. The stainless steel pump coupling mainly has the rigid coupling and the tooth shape coupling. (1) rigid couplings. Rigid coupling is generally used in power on small centrifugal pump, test and bolts removed when the first rubber elastic ring, the liquid temperature is not high, two plane gap coupling is 2,2 ~ 4,2mm, when the temperature is high, should be greater than the amount of 1,55 to 2,05mm before the escape, the coupling rubber elastic ring than the perforation diameter small 0,15 ~ 0,35mm, must use special things, link smooth assembly and disassembly, does not allow any bumps scratches. (2) gear coupling. The tooth coupling flexible is better, has the automatic centering function, when the overhaul generally performs according to the following way:. Check the gear teeth meshing situation, the contact area along the tooth height is not less than 50%, along the tooth width is not less than 70%, the tooth surface shall not have serious pitting corrosion, wear and cracks. Stainless steel pump coupling outer ring gear, radial runout is not greater than 0,03mm, the end of the circle beating is not Nianye 0,02mm. If it is necessary to remove the gear ring, it is necessary to use special tools, not to beat, so as not to bend or damage the shaft. When it is installed, the gear ring should be heated to 200 degrees, and then mounted on the shaft. The interference of the outer ring and shaft is usually 0,01 to 0,03mm. The back loading center tube or other components, should be according to the original logo and data assembly. Use torque to move the hand and tighten the bolt evenly. 2, the dynamic seal Department overhaul. The centrifugal pump seal is a sealing blade ring position, the general direction of radius should be controlled at 0,20 ~ 0,45mm, Wakama Ta small, after assembly turning hard, clearance is too large, causing the vibration of the pump easily, sleeve and lining ring clearance radius direction is 0,2 ~ 0,6