可否用直流电压挡测质变频器的输进电压？(国外英文资料).docVIP

能否用直流电压挡测量变频器的输出电压？(国外英文资料) Can I use the DC voltage barrier to measure the output AC voltage of the converter? There is a master with the disciples heard that some DC voltmeter block, the AC output voltage to measure the frequency converter, and thus determine the inverter module is good or bad, even can decide which one (ARM) inverter module is good or bad, even can determine the performance of the inverter module deterioration phenomenon than AC a more intuitive and effective measure. Is it possible to measure AC voltage with dc gear? Will it burn out the multimeter? The disciple felt that he had no heart, so he asked his master if he could measure the output voltage of the frequency converter with the DC voltage The master said, what do you think? The teacher pondered for a while, and asked the disciple again: if you can measure the AC voltage with the DC gear, then why does the multimeter need to distinguish the DC gear and the AC Gear? Master, this is for questioning. The apprentice thought, too, that the master said it was reasonable and could not refute it himself. But could not understand the subtle heart or depressed, to find their own professional brothers to discuss, we have said, all sorts of gossip, some say, is not a unified opinion. The second day, the workshop has a good frequency converter, one of the brothers took their MF47 pointer multimeter to DC 500V gear, so, when I first eat crabs, if burned my table, everyone is also a lesson to know the pear Zi taste, should taste good. You will connect the inverter power line, the brothers will multimeter pen lap to drive the U and W output terminals. You start a converter, start the initial stage, the lower frequency, see the multimeter hands swinging back and forth, with the rise of the start frequency, the swing speed accelerated, swing becomes small, above 15 Hz, only see the pen in the 0V position extremely small rapid small swing, frequency to rise, steady hands at zero, almost can not see the swin