后浇带是现浇整体式钢筋混凝土结构施工期间(国外英文资料).docVIP

后浇带是现浇整体式钢筋混凝土结构施工期间(国外英文资料) Tenth pages, 10 pages After pouring zone during the whole cast-in-situ reinforced concrete structure construction, in order to overcome and may be due to temperature, shrinkage and setting deformation joint of harmful cracks, after a certain time after pouring closed, the formation of the whole structure. Since the structure is made up of the back pouring belt, the quality of the post pouring belt is closely related to the quality of the structure. After the pouring zone is often large section, steel reinforcement, formwork support difficult, especially debris, garbage easily fall into, cleaning is very difficult, if not clean thoroughly, will affect the quality of the structure. The construction method of the back pouring band in cast-in-place concrete structure is introduced. construction technology (1) structural measures for the bottom pouring band 1, the bottom plate, the back pouring belt, the touching plate support ? the bottom thickness of 0.6m, after pouring by 2 with 25 steel skeleton in post cast band steel mesh as side formwork support, lashing on the steel skeleton. Vertical bars with diameter of 25@250. In order to ensure the quality of structural construction, the steel frame of the post pouring belt shall not be welded on the floor reinforcement. 2. Temporary protection measures for the bottom pouring belt During the period after the vacant of the casting belt, in order to prevent sundries and sewage from entering, the following measures can be taken: 120mm wide and 60mm high brick band shall be built on the back of the base board. The brick band and the floor surface corner are coated with 1:2 cement mortar to form an arc, and the upper part is completely closed with plywood or woven cloth. (two) the structural treatment of the back wall of concrete wall 1. The protective measures of the backfill belt before and after backfill ? because of the short construction period, the construction of the buildings surrounding the s