焊缝质量标准和焊缝等一,二,三级分类(国外英文资料).docVIP

焊缝质量标准和焊缝等一,二,三级分类(国外英文资料) Weld quality standard and weld grade classification Weld quality standard 4.1 ensure the project 4.1.1 welding materials shall comply with the design requirements and relevant standards, and shall check the certificate of quality and baking records. 4.1.2 the welder must pass the examination and check the qualification certificate and the date of examination of the welders corresponding welding conditions. The welds of grade 4.1.3 and II must be inspected by flaw detection, and shall comply with the requirements of design, construction and acceptance specification, and check weld defects report. 4.1.4 class I and II weld seam surface shall not have cracks, overip, burn, arc pit defects. No defects such as surface air holes, slag inclusion, arc pits, cracks and arc abrasions can be found in the secondary welds, and no defects such as undercut and welding are allowed in the welds. 4.2 basic items 4.2.1 weld appearance: uniform weld shape, smooth transition between bead and bead, bead and base metal, clean welding slag and spatter. 4.2.2 surface porosity: class I and II weld does not allow; allow a diameter less than 0.4t per 50mm grade weld length of weld in 2 and less than or equal to 3mm; stomatal stomatal distance is less than or equal to 6 times the aperture. 4.2.3 undercut: Grade I welds are not allowed. II: weld undercut depth of less than 0.05T and less than or equal to 0.5mm, the continuous length is less than or equal to 100mm, and both sides undercut length of weld length is less than or equal to 10%. III: weld undercut depth is less than or equal to 0.lt and less than or equal to LMM. Note: t is thinner at the connection plate. 4.3 allow deviation items, see table 5-1. 5 finished product protection 5.1, welding is not allowed to hit and hit the joints, not to just finished welding water on the steel. Slow cooling measures should be adopted at low temperature. 5.2, not allowed to weld outside the base material on the arc. All 5.3 m