塔机检查表(国外英文资料).docVIP

塔机检查表(国外英文资料) Table 2-1-9 tower checking table (field) The project name Equipment installation location Device name Type no. The serial number Check the project Check volume In question 1 base this to o The safe distance between any part of the tower and the overhead transmission line In the case of an overhead transmission line, any part of the tower should meet the specified requirements for the safe distance of the overhead transmission line. The minimum distance between two tower machines Ensure that the lower part of the tower is at least 2m away from the tower of the other tower. In a high tower crane jib within the radius of gyration in lowest position of the components of high speed and low speed in the vertical distance between the top part should not be less than 2 m. At the same time, there should be several safety and technical measures for job security. 1.3 free end height Not exceeding the height permitted by the instruction manual. The tower of the 1.4 tower is vertical The requirements of the vertical scale of the tower should meet the requirements. 2 base development 2.1 basic requirements Conforming to the use of instruction manual or design requirements; The calculation of the calculation of the calculation and the drawings shall be examined and approved by the competent technical director of the construction unit; The foundation must be approved by the construction and supervision units; The pre-buried bolts shall be certified by the product, and the pre-buried and the connection shall meet the requirements. 3 attached 3.1 attached device Comply with the requirements of the tower machine the instruction manual or the overall stability of the tower machine. The design should be carried out when the attachment distance is greater than the requirement of the instruction manual. The serial number Check the project Check volume In question 3 attached 3.2 attached spacing The spacing of the attached device and its setting shall be in accordance with th