【2017年整理】曲面造型练习.pptVIP

01矩形圈 (扫描曲面，壁厚5) 02椭球 (扫描曲面) 03壳体 扫描截面轮廓、路径、三条引导线（需要5个草图） 前端圆角R5 后方圆角R7 顶面圆角R4 底面圆角R1 顶部凹陷(拉伸曲面之后剪裁曲面) 顶面椭圆切口（剪裁曲面） * 此矩形外轮廓为扫描引导线 直径60的圆为扫描路径 扫描轮廓为一个椭圆 先画路径、引导线（2个草图），然后画扫描轮廓，添加扫描轮廓与路径、引导线草图的“穿透” 约束。 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 此椭圆为扫描引导线 扫描轮廓为此椭圆的一半 扫描路径为一个任意圆 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 此闭合区域为扫描轮廓 此直线为扫描路径 此曲线为扫描引导线 此曲线为扫描引导线 此曲线为扫描引导线 注意：一定最后画扫描轮廓，并添加扫描轮廓与其余草图的“穿透”或“重合”约束。 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 左右两端用“平面区域”封闭，然后缝合曲面 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd.