BSS内部语音通道告警(国外英语资料).doc

BSS内部语音通道告警 Single notification police processing 1: shall: Single circular p BSC side open, open the secondary single-pass detection (BSC level two parameters, and village level below parameters) SET BSCINNSOFT voice channel alarm threshold = 10 (the system default 10, need to check), voice channel alarm recovery threshold = 6 (the system default 6, need to check). Single circular p BTS side open: all district Open the single-pass detection level six parameters (village) : SET GCELLSOFT primary single detection switch = open, the primary single pass inspection cycle = 5, the primary single-pass bad = 25 frames threshold method, the secondary single-pass detection switch = enabled, secondary single-pass TRAU frame issued by cycle = 2 = 4, secondary single pass inspection cycle. It is helpful to deal with the fault area in advance to avoid customer complaints. 2: processing flow: Step 1: see the alerts BSC for the need to be aware of the BSS internal voice channel alarm for multiple periods of time and record the time of occurrence. Step 2: make a notice to the police log as shown below: BSC maintenance - BSC field information collection - select the 2G voice single-pass log in the list of file types. In the upload Settings, the FTP server IP fills the IP, the upload path, the LOG address and the password of the FTP account are admin. Download the LOG and upload it to your personal computer, and LOG the following: The LOG in attachment: Take the LOG Settings Step 3: LOG out after the LOG analysis to analyze the LOG, the main reason for the current conduction in was a hardware failure is given priority to, including transmission CIC link failure and carrier frequency of failure is the most widely, access to the LOG analysis is look at single focuses on which area of the carrier frequency, or whether the concentration in a transmission time slot, if the focus is on the carrier frequency for resetting or replacement, will be treated as fault transmission time slot. 3: c