SEW MOVIFIT培训_Workshop_FC-Technology_Transparent_EN.pptVIP

Gültig ab 01.01.2004 / Version 1.0 Presentation title SEW-Eurodrive - Driving the world MOVIFIT FC (Inverter) Features (I): Open-loop frequency inverter No encoder feedback Positioning with ES16/NV26 Power range Size 1 = 0.37 kW to 1.5 kW Size 2 = 2.2 kW to 4 kW Voltage range 3 x 380 – 500 V Brake control for 110 V, 230 V, 400V (SEW brake) Digital output can be configured for non-SEW brake control (DB00) MOVIFIT FC (Inverter) Features (II): Local inputs/outputs MOVIFIT FC (Inverter) Features (III): Braking resistor Internal or external Size 1 = BWT1 (min. R = 150 Ohm) Size 2 = BWT2 (min. R = 68 Ohm) Intelligent distribution of regenerative energy to brake coil and braking resistor Safe stop Stop category 0 according to EN 60204-1 Safety category 3 to EN954-1 Motor startup via Movitools MotionStudio Easy mode: Simple startup of FC via DIP switches Expert mode: Expanded startup of FC via fieldbus or MotionStudio Startup in Easy mode (I): Startup in Easy mode (II): Setting the Profibus address Switching the bus terminating resistor on/off Startup in Easy mode (III): Configure MOVIFIT FC (DIP switch S10) Set Easy mode operating mode (S10/1=off) Set additional parameters to table Startup in Expert mode (I): Startup in Expert mode (II): Setting the Profibus address Switching the bus terminating resistor on/off Startup in Expert mode (III): Configure MOVIFIT FC (DIP switch S10) Set Expert mode operating mode (S10/1=on) Set additional parameters in MotionStudio Startup in Expert mode (IV): Start MotionStudio Create a new project Startup in Expert mode (V): Start Secos Establish connection to unit Startup in Expert mode (VI): Execute Online scan Detected devices will be displayed Startup in Expert mode (VII): Highlight power section (address 1) Open Parameter tree Startup in Expert mode (VIII): All parameters have been set to default value at factory Set additional parameters, if necessary: Setpoints Motor parameters Monitoring functions Function of