超市仓库管理系统业务流程图doc.doc

《信息系统分析与设计》期末考试 2010级信管专业1A班 2012/2013学年第一学期 系统分析与系统设计报告 系统名称：超市仓库管理系统 序号： 学号： 姓名： 完成时间：  一、系统概述 系统名称：超市仓库管理系统。 基本用途：管理超市商品的存取相关业务活动。 主要功能：处理超市商品从进货/取出，记录，分类，安排商品进出。 二、业务分析 1.存入仓库。 2.从仓库取出。 三、系统逻辑模型 数据流图索引 图0仓库数据流图 1商品处理 2存入处理 3取出处理 同一件商品编号相同，只需记录和修改存入和取出的数量即可，所以步骤和存入相同。 4查询处理 1.1商品编号 系统结构设计 数据库设计 数据库表 商品表（商品编号*，库存，存取数量，存取时间） 取出情况表（时间，数量，剩余，商品编号*） 存入情况表（库存不足，损坏，过期，需要处理） 六.处理流程设计 取货流程 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface, markup should be in ac