供配电装备的标识(国外英语资料).docVIP

供配电设备的标识(国外英语资料) In order to facilitate the management of equipment, after the acceptance of power supply and distribution equipment, the power supply and distribution equipment should be unified identification, marking should be accurate and complete. 1, bus identification standard in the power supply system, three-phase power supply phase sequence identification. We respectively arrange the order in the three-phase power supply, such as the top, middle, bottom, or left, middle, and right, in English letters A, B and C. The zero line is marked by N and ground wire with E. In the color mark, according to the provisions, the power supply arrangement of A, B and C three-phase alternating current corresponding colors are yellow, green and red, neutral line color is light blue, grounding wire to yellow / green two color logo. So, can the corresponding A, B, C, N, E letters in the logo on the bus. 2, the high-voltage circuit identification in high-rise building power supply in general, with the introduction of electric cable to substation building, the internal high voltage switch cabinet or ring network cabinet, converted by the step-down transformer into low-voltage supply to the users, so in the substation high voltage switch cabinet or ring network cabinet, high voltage circuit the logo can be taken the following way: the high-voltage line total circuit to electric power supply circuit named mark. Such as XX substation, XX line, F24. The high voltage outlet circuit is identified by the position of the transformer supplied in the cabinet arrangement. The cabinet next to the main cabinet is the first cabinet, followed by second and third counters...... Therefore, the high voltage outlet circuit can be identified as: KMAN, PMAN, where K and P represent the loop number, M stands for the location of the sub cabinet, and AN stands for the transformer number supplied by the cabinet. Example K4A5 indicates that the K loop is divided into fourth cabinets for transformer No.