单台汽泵跳闸处理方法--千伏网(国外英语资料).doc

单台汽泵跳闸处理方法--千伏网(国外英语资料) Treatment method for single steam pump trip - kV network The software standard drawings | electrical thermal boiler turbine Journal of fuel chemistry scheduling | hydropower wind power nuclear power The information design and construction supervision safety examination training management | EHV | operation | maintenance company products | recruitment community. Member landing: Your current position: kV network article center steam article text user login new user registration Single steam pump trip treatment method [font: small big] Treatment method of single steam pump trip Author: anonymous source: unknown hits: 66 update time: 2006-6-14 1: first start the electric pump immediately, cut another steam pump automatically for manual, then pump, and reduce load to between 260 - 280MW (according to the drum water level). Because the electric pump does not automatically, so the pump before RB positive action, load may have been reduced to 150MW or just 10-20MW, the furnace may have automatic oil D withdrawal B, C or D layer powder being cast layer of oil (and sooner or later found and start the pump speed and decide), but no matter how, as long as the start of the electric pump can maintain normal 260-280MW drum level certainly, it should be removed and put into the root to burning oil just automatically removed powder, maintain stable pressure. 2: if the pump fails to start, RB, automatic load reduction to 150MW, and automatic D oil withdrawal B, C powder, the furnace should immediately be cast A (fire), oil layer from F layer powder, and cut off the E automatic blood pressure rapidly. In order to water turbine should immediately on the other a steam pump steam source down to the preparation of steam zone (when the general water level is difficult to maintain, hence there is a need to reduce load, and load reduction of 4 pressure drop, steam pump to maintain high speed, drum water level cannot be maintained and form a vicious spiral) and report