变速箱(国外英语资料).docVIP

变速箱(国外英语资料) Transmission oil inspection and replacement stall test Self diagnostic system applies oil pressure test Transmission oil inspection and replacement The automatic transmission oil must be replaced every 30000 miles, and the DEXRON model automatic transmission oil is used. Replace the gearbox oil after the oil surface inspection standards, should be carried out in the hot state. That is, let the transmission oil temperature arrive After 70~80 DEG (160~180 DEG F), the gear lever is discharged several times in the first gear, and then stays in the N space The file position, then take out the dipstick), check whether the HOT range, if the oil shortage is appropriate to be added. Note: automatic gearbox oil, must comply with the provisions of the hot state check, or accidentally added excess Transmission oil, when the temperature increases, the expansion of the oil surface increases, resulting in accelerated transmission, it is easy to cause gear loss Bad. In addition, the gas vent of the transmission should also be kept clear and clean, otherwise it will cause the oil temperature to be too high, and then hurt Transmission performance. Stall test (a) so-called stall test (two) stall test procedure (three) diagnosis of stall test The inspection of the automatic transmission, in addition to the fault of the circuit system, can be read by the self diagnostic system, such as the outside of the fault code If the clutch is skid, the stall test shall be carried out; if the oil leak occurs, the oil pressure test shall be performed in order to be advantageous Exclusion problem. (1) the so-called stall test The so-called stall test, that is to check whether the automatic transmission clutch is slipping test. In other words, stall tests The method is to start the engine, step on the brake, and change the gear lever into the D or R gear and accelerate the accelerator to the end, Observe whether the engine speed remains within the range of 1800 to 2800RPM, to judge the tor