大型油-气套管变压器现场局放试验及故障诊断(国外英语资料).docVIP

大型油-气套管变压器现场局放试验及故障诊断(国外英语资料) Field PD test and fault diagnosis of large oil gas casing transformer Source: China Motor maintenance network add time: 2005-11-4, 12:50:38 browsing: Preface Changchun power supply company has built a 220kV central substation in the city network reconstruction project. In order to reduce the gross area, the high voltage 220kV and the low voltage 66kV side of the substation adopt cable outlet. Switch factory selected GIS combination appliances. There are 2 sets of 180MVA oil insulated bushing main transformer in substation. Taking into account the importance of load and geographical location, the main transformer chose a transformer produced by a famous joint venture factory in china. After the transformer is installed, routine high voltage test and chromatographic analysis are carried out according to the regulations. All the tests are qualified. After more than 72h static discharge, partial discharge tests were carried out on 2 transformers. The experimental results show that the #2 main transformer put test once passed, A, B, C three NQN were about 50pC; the test voltage A voltage to the rated #1 main transformer in 1 / 3 (relative to A voltage is about 73kV), the partial discharge quantity is more than 1 million pC regulations far more than the rules of less than 500pC; chromatographic partial discharge test after analysis found that oil acetylene value increased from 0 to 16 before the test * 10 - 6 L. The results of the two tests have proved that the main transformer of #1 is in a serious discharge fault, and it must be checked before it can be put into the running of the system. Field discharge test of 1 large oil gas casing transformer Generally speaking, it is much more difficult for oil field bushing transformer on-site test to be larger than ordinary bushing transformer. This is because when the oil gas casing transformer is tested, the non test case is connected to the ground, and the test case needs to be fitted with a temp