工业废水处理(国外英语资料).docVIP

工业废水处理(国外英语资料) Application of 7. membrane separation technology in industrial wastewater treatment 7.1 ultrafiltration treatment of crude oil wastewater The crude oil content in crude oil containing wastewater is usually 100~1000mg/L, exceeding the national emission standard (10mg/L), so the oil discharge must be removed. Although the existing methods have some effects, they have obvious shortcomings. The oil can only remove the size of more than 30 mu m oil, can not remove dissolved oil and emulsified oil; flotation method to add oil demulsifier, not easy to use; the removal of emulsified oil difficult coarse graining method; biochemical method of large area, more energy; the French Open Phase blocking activated carbon cloth. Adsorption of activated carbon and high cost, not easy regeneration. The above methods are difficult to be popularized in industry, but the petroleum industry urgently needs an effective and suitable method for industrial application to treat oily wastewater. Application of hollow fiber ultrafiltration membrane and ultrafiltration equipment, the operation pressure is 0.10MPa, water temperature of 40 DEG C, the membrane permeable rate of up to 60~120L/m2, h, 200~1000mg/L can take the crude oil containing wastewater treatment and meet environmental emission standards. The ultrafiltration equipment runs for more than 500 hours, and the penetration rate of the equipment is more than 2 tons per hour. In all kinds of dope concentration, temperature, through the liquid content of crude oil is lower than that of 10mg/L, through calculation and comparison, compared with the old process ultrafiltration 36.5% energy saving, covers an area of 25.2%, saving the investment of 16.3%, annual operating cost savings of 12.4%. Treatment and reuse of waste liquid of 7.2 banknote printing plate The waste liquid of banknote printing and wiping plate is the main wastewater discharged into the water body. Its main ingredients include deionized water, NaOH (~10g/L),