第4章 平面连杆机构(国外英语资料).doc

第4章 平面连杆机构(国外英语资料) The fourth chapter plane linkage mechanism Fill in the blanks 1. the basic motion of a rigid body is,. 2., when the rigid body translation, just inside the same points. At the same instant, just inside the body And the same. 3. angular velocity is used to measure the physical quantities of a rigid body; the physical quantities used to measure angular acceleration. 4. when analyzing the motion of points by means of synthetic motion of points, we should distinguish three kinds of motion, in addition to the two reference frames. 5. under the condition, the crank slider mechanism has the quick return characteristic. The sum of the drive angle gamma and the pressure angle alpha in the 6. mechanism is equal to. 7. in the hinge four bar mechanism, when the sum of the length of the shortest component and the longest member is greater than the sum of the length of the other two members, the mechanism can only be obtained. 8. plane linkage is a mechanism formed by the coupling of many rigid components. 9. in the guide rod mechanism, when the AB is an active member, the angle of transmission of the mechanism is. The INCLUDEPICTURE /web_old/xi_bu/ji_dian/jing_pin/ji_xie/xtkt/xt3.ht1.jpg MERGEFORMATINET 10. in the oscillating rod mechanism, guide rod swing angle of 0 DEG =3, the variation coefficient of travel speed K value. 11. in the four bar linkage, the LAB=40mm, lBC=40mm, lCD=60mm, and AD are racks, and the mechanism is. The 12. hinge four bar linkage has the angle of the extreme position, the theta value and the theta value of the crank slider mechanism, so its quick return characteristic and the quick return characteristic of the swinging guide rod mechanism. 13. pairs of crank slider mechanism, crank length is a, connecting rod length is B, then the minimum drive angle min is equal to, it appears in position. 14. in the four linkage mechanism, the mechanisms that can achieve quick return motion are (1), (2), (3). The condition of 15. hinged four bar me