隔离式与非隔离式的差别(国外英语资料).docVIP

隔离式与非隔离式的区别(国外英语资料) The difference between isolation and non isolation: It is a transformer with equal voltage and equal current, but it is isolated from the external grid so that it can be bought or can be made by itself. Isolated voltage regulator and non isolated voltage regulator, is a power chip isolated voltage regulator and linear power supply and switching power supply? Is actually a special transformer, but it is not the function of pressure, because the number of laps and the line of his two coil diameter are exactly the same, so you can play the role of isolation and power grid, using inductive current transformer function only, for safety, with input and output voltage is equal to (220V) transformer, and the output and input (output from completely isolated ground), will open the device to isolate the electrical equipment and power, power is the isolation between isolated and non isolated isolation mainly lies in the regulator input circuit and the output circuit is not altogether, rather than isolated is the common ground. In general, non isolated inductors have both primary and secondary sides, while isolated ones have only one inductor. In high power and ground interference protection requirements are relatively high, the use of isolated type, in relatively simple and relatively tight volume requirements of the use of non isolated type. If the linear power supply refers to the linear adjustment output module (LDO), then the linear module must be non isolated, so the power chip is an isolated voltage regulator and has no relation to the linear power supply and the switching power supply. Isolation and non isolation are two major categories of switching power supplies. The difference between isolation and non isolation is mainly that the isolation regulator input circuit and output circuit are not common, and the isolated type is common. In general, non isolated inductors have both primary and secondary sides, while isolated ones have only one inductor