工程机械现场的应急维修小方法(国外英文资料).docVIP

工程机械现场的应急维修小方法(国外英文资料) Small method of emergency maintenance in engineering machinery field One, the reason that the component does not work normally and how to solve in the field 1. Parts installation errors such as some engineering machinery hydraulic cylinder seals of the support ring (mainly made of tetrafluoroethylene filling materials) of the elastic is poorer, therefore before installation should be the first in 100 oc oil soaked 10 to 20 minutes, make its become soft, then take the elasticity is larger when fitted. The problem of the parts operation is more problematic, especially when the new driver is not familiar with the performance of the machine. For example, there is a truck axle shaft spline often wear, later found to be the pilot make differential lock has not release, leading to increased when using the load of transmission parts, the serious wear and tear, so to improve the operation. Damage to parts caused by the failures of the related parts of the 3. For example, a digger on two walking hydraulic motor is broken at the same time, through inspection, is a multiple oil seal on the swivel joint damage caused by a blocked the circuit, so to solve this problem, otherwise the future hydraulic motor will be damaged. 4. Parts quality problems such as excavators, hydraulic motor, hydraulic pump, gear reducer bearing has been damaged, replace the original bearing or bad, after finally installed imported bearing is solved the problem. In the same way, the oil seal of the excavated arm cylinder was often damaged in the summer, and it was found that the piston of the original plant was too large for the cylinder. When the piston was reprocessed on the scene, the oil seal was never broken. Several kinds of emergency maintenance skills The bolt is twisted by a wrench Sometimes due to lack of suitable spanner, it is difficult to assemble parts, especially some bolts of imported engineering machinery, which are not big or small when unpacking. In addition, som