总线进进法(国外英文资料).docVIP

总线进入法(国外英文资料) 1 a variety of user remote control changes factory remote control method A variety of user remote control changes factory remote control method Different color TV, the method that enters the maintenance state is not identical, there are three main methods; One, maintenance switch entry method: the circuit board of this color TV has a maintenance switch, need to press this switch color to be able to enter the maintenance condition. Like summer wah S07 machine core color TV, press on main circuit board the maintenance switch S804 can go into maintenance condition. Short answer test point entry method: this color TV is used for short or instant short answer test points (or test points and ground). For example, in the case of changhong CN - 5 machine core color TV repair mode: open the shell, short-circuit the N201 (9) foot to the ground, and then turn on the maintenance mode. The N201 (36) feet can be short-circuited to the ground, or it can also enter maintenance mode. The music of the RG29W - 100Hz, RH29W - 100Hz, RF29W - 100Hz, etc. There are two ways to get into maintenance; One foot is directly to the CPU (36) of instantaneous short circuit, the second is instantaneous short lu yao on coding of integrated circuit (3), (11), the state of maintenance, according to the P + / P - button to adjust project, press V + / V - keys to adjust the data. According to the TV button on the remote control can quit factory debug mode. Third, password entry method: this is the method that most bus color current enters the maintenance state. When entering maintenance state, use the remote control and the native keyboard to write the password in order. Most color TV just according to the rules of operation operation user remote controller and the machine is key to enter, some color need factory dedicated remote control or remote control to the user after transforming to enter state of repair and maintenance. The following is a method for converting remote controls to a