日立(HITACHI)SJ200变频器故障信息(国外英文资料).docVIP

日立(HITACHI)SJ200变频器故障信息(国外英文资料) Hitachi frequency converter fault processing One, E01 constant-speed runs over the stream The reason: 1, the load suddenly becomes small, 2, the output short circuit, 3, l-pcb and ipm-pcb connection cable error, 4, ground fault Measures: Increase frequency converter capacity, 2, use vector control mode Description: CT detection The E02 decelerated through the stream The reason: 1, the sudden change of speed, 2, the output short circuit, 3, ground fault, 4, decelerate time too short, 5, the load inertia is too big, 6, the braking method is not suitable Measures: Check the output, 2, extend the deceleration time, 3, use the fuzzy logic to add deceleration, 4, check the braking mode Description: CT detection Third, E03 accelerates the flow The reason: 1, the sudden changes in load, 2, output short circuit, 3, ground fault, adjustment is too high, 5, 4, start frequency torque increasing too high, 6, stuck, 7, accelerating time is too short, 8, connection between the inverter and motor cable is too long Countermeasures: , 2, 1, the use of vector control torque increase, 3, extend the acceleration time, 4, and increase the capacity of the inverter, 5, and using the fuzzy logic function of acceleration and deceleration, 6, shorten the distance between the inverter and motor, 7, debugging A69-70 15 ~ 40 hz (SJ300 series) range Description: CT detection Four, E04 stops the flow The reason: 1, CT damage, 2 power module damage, 3 cooling fan is stuck or damaged Five, E05 overload The reason: The load is too heavy, 2, the electronic heat relay threshold is too small Countermeasures: Reducing load, 2, increasing frequency converter capacity, 3, increasing electronic heat relay threshold 6, E06 brake resistance overload protection The reason: 1, the regenerative braking time is too long, 2, l-pcb and ipm-pcb connection cable error Countermeasures: The deceleration time is extended, 2, the capacity of the frequency converter, 3, A38 is 00, 4, increa