汽车刹车片生产加工涉及到的机械设备和工艺流程(国外英文资料).docVIP

汽车刹车片生产加工涉及到的机械设备和工艺流程(国外英文资料)The mechanical equipment and process process involved in the production and processing of the brake pads are reproduced and reproduced with the copy address log address:Use Ctrl + C to copy and post it to your friends.Reprinted from the reading (10) review (10) review (0) : personal diaryReport fonts: large size is small and largeA straight line of grinding power conveyer and conveyer line;Line grinder + saw bed: grinding PAD powder; Powder block chamfering Angle (inverted Angle is mainly used to brake when turning the car); Cut the slot (which helps the car to cool down);3) shot blasting machine: used for the cleaning and blasting of the PAD.Steel backshot pill: check the roughness (check the seal) and remove the skin.Powder production line:The speed of the drying track;02, powder: flat light powder, sandy grain powder;The heat pipe;04, coating covers area;(5) painting appearance (surface effect);06, coating adhesion;07, the drying temperature;08, coating thickness;2009, MEK tests;10, the verification table display technique;11, 100.12, the cotton sticks are not black;5, hot press:01, current;02, electric phase: A, B, C;03, temperature control;Oil pump start/stop;Automatic/manual;06, PLC run/switch;07, switch;08, walk and fall on the platform;Up and down the main cylinder;10, the thermocompression of the laminated cold press: the powder is moulded by cold pressure, and then the hot pressure.4 injection press, mold cavity;Six, cold press;7, cloth glue machine:Quality control point: steel back coating area: 100%; Drying of the gel: hands not sticky;8) rectilinear grinding dust box;Air compressor;10, cleaning machine dust box;Air blowers back blow;All suction surface grinding machines;Heat treatment oven:01, voltage;02, current;03, parameter input;04, temperature control watch;Manual/automatic;06, start/stop;07, heating/insulation;The windmill;09, power supply;10, call the police;14, roller shot blasting machine (steel back shot shot) :Re